LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Battery, Charging System And Starting System) >> Repair Instructions >> Ground Strap Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ground Strap Nut
    GM663474Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the ground strap to the stud.
  2. Install the ground strap nut to the stud at the front of dash.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    4. Fig 2: View Of Ground Cable Bolt At Engine Block
    GM663475Courtesy of GENERAL MOTORS CORP.
  4. Position the ground strap and engine wiring harness ground.
  5. Install the engine wiring harness ground bolt.

    Tighten:  Tighten the bolt to 16 N.m (12 lb ft).

  6. Install the left hand catalytic convert. Refer to Catalytic Converter Replacement (Right Hand) in Engine Exhaust.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals