LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Control System - Removal & Installation) >> Fuel Systems >> Fuel Pump >> Removal

Fuel Pump: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The numbers in parenthesis in removal and installation procedures refer to numbered components in referenced figure(s).
  1. Remove the fuel sender assembly. See FUEL SENDER ASSEMBLY  .
  2. Remove the lower cap (9) and the lower cushion (8) from the fuel sender assembly. See Fig 1 .
  3. Remove the fuel pressure regulator (6).
  4. Disconnect the fuel level sensor harness connector.
  5. Remove the fuel level sensor (3).
  6. Remove the fuel sender top cap (2) from the fuel filter assembly.
  7. Disconnect the fuel pump harness connector.
  8. Remove the fuel pump (11) from the fuel filter assembly (13). See Fig 1 .
  9. Remove the locking ring (10) for the fuel strainer from the fuel pump. See Fig 1 .
Fig 1: Exploded View Of Fuel Sender Assembly
G00180641Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals