LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Electrical >> Body Electrical >> Wiring Systems - Introduction >> Repair Instructions >> Instrument Panel Electrical Center Or Junction Block Replacement - Left >> Installation Procedure

Installation Procedure

  1. Install the fuse block onto the IP assembly till it clicks in place.
  2. Install the wire harness block to the back of the fuse block.
    3. NOTE: Refer to Fastener Notice  in Cautions and Notices.
  3. Install the bolt.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in).

  4. Install the turn signal relay to the back of the fuse block.
  5. Using the wiring diagram on the cover of the fuse panel, install the fuses.
  6. Install the electrical connectors.
  7. Install the knee bolster. Refer to Trim Panel Replacement - Knee Bolster   in Instrument Panel, Gages and Console.
    8. Fig 1: Left Instrument Panel Electrical Center Or Junction Block
    GM386487Courtesy of GENERAL MOTORS CORP.
  8. Install the left side end panel.
scientia non olet · About LEMON Manuals