LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Electrical >> Body Electrical >> Wiring Systems - Introduction >> Diagnostic Information & Procedures >> Testing For Short To Ground >> With a DMM

With a DMM

  1. Remove the power feed (i.e. fuse, control module) from the suspect circuit.
  2. Disconnect the load.
  3. Set the rotary dial of the DMM to the Ω position.
  4. Connect 1 lead of the DMM to 1 end of the circuit to be tested.
  5. Connect the other lead of the DMM to a good ground.
  6. If the DMM does NOT display infinite resistance (OL), there is a short to ground in the circuit.
scientia non olet · About LEMON Manuals