LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Steering Wheel And Column >> Repair Instructions >> Steering Wheel Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SERVICING THE SIR SYSTEM CAUTION .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
  2. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
    Fig 1: Removing/Installing Air Bag Module
    GM731656Courtesy of GENERAL MOTORS CORP.
  3. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.
  4. Disconnect the steering wheel electrical connector.
    5. Fig 2: Removing/Installing Steering Wheel Retaining Nut
    GM731652Courtesy of GENERAL MOTORS CORP.
  5. Remove the retaining nut which secures the steering wheel to the steering wheel shaft.
    6. Fig 3: Installing J 1859-A With J-36541-A Or J 42578 To Steering Wheel
    GM750717Courtesy of GENERAL MOTORS CORP.
    NOTE: When removing the steering wheel, use only the specified steering wheel puller. Do not hammer on the end of the steering column shaft. Hammering could loosen the plastic injections which maintain the steering column rigidity.
  6. Install J 1859-A  with J-36541-A  or J 42578  to the steering wheel. See Special Tools .
  7. Remove the steering wheel using J 1859-A  with J-36541-A  or J 42578  . See Special Tools .
scientia non olet · About LEMON Manuals