LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Steering Wheel And Column >> Repair Instructions >> Steering Column Seal Replacement >> Installation Procedure

Installation Procedure

    NOTE: Refer to FASTENER NOTICE .
    Fig 1: Upper Intermediate Shaft Boot
    GM793261Courtesy of GENERAL MOTORS CORP.
  1. Install the upper intermediate shaft boot.

    Tighten:  Tighten the upper intermediate shaft to boot nuts to 50 N.m (37 lb ft).

    2. Fig 2: Upper Intermediate Shaft & Lower Intermediate Shaft
    GM793256Courtesy of GENERAL MOTORS CORP.
  2. Connect the upper intermediate shaft to the lower intermediate shaft.
  3. Install the upper intermediate shaft to the lower intermediate shaft pinch bolt.

    Tighten:  Tighten the upper intermediate shaft pinch bolt to 50 N.m (37 lb ft).

    4. Fig 3: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  4. Unlock the steering column by removing J 42640  from the steering column lower trim cover access hole.
scientia non olet · About LEMON Manuals