LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Front End >> Repair Instructions >> Hood Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Cable End & Hood Release Handle
    GM833078Courtesy of GENERAL MOTORS CORP.
  1. From the driver's side compartment area, route the cable through the access hole in the cowl (2).
  2. Attach the retainer clips that retain the hood release cable to the cowl.
  3. Connect the cable end (1) to the hood release latch.
  4. Set the hood release handle in place.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the fastener retaining handle to the vehicle.

    Tighten:  Tighten the fasteners to 9 N.m (7 lb ft).

  6. Install the driver's side kick up panel. Refer to Kick-Up Panel Replacement - Front Floor .
scientia non olet · About LEMON Manuals