LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers/Washer Systems >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

IMPORTANT: If replacing reservoir, make sure to transfer all necessary components.
  1. Connect the washer level sensor electrical connector.
  2. Connect the washer pump electrical connector.
  3. Seat the washer hoses in the grooves on the washer bottle, and connect the hoses to the "T" connector at the motor.
  4. Set the solvent container in place on the vehicle, but do not install the fasteners.
    5. Fig 1: Front End Inner Side Panel Gusset
    GM833961Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the front end inner side panel gusset (2) and the fasteners retaining it to the vehicle.

    Tighten:  Tighten the fasteners to 25 N.m (18 lb ft).

  6. Install air cleaner assembly.
  7. Fill the washer solvent container.
scientia non olet · About LEMON Manuals