LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting Systems >> Repair Instructions >> Headlamp Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Wiring Harness & Headlamp
    GM1467135Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Connect the wiring harness.
  3. Install the headlamp.
  4. Ensure the alignment pin (4) is positioned to the housing (2).
    5. Fig 2: Locating Retaining Nuts & Connecting Electrical Connector
    GM1467132Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the retaining nuts (3).

    Tighten:  Tighten the nuts to 6 N.m (53 lb in).

  6. Connect the electrical connector (4) to the headlamp bulb socket.
  7. Close the hood.
  8. Install the grille. Refer to Grille Replacement in Exterior Trim.
scientia non olet · About LEMON Manuals