Confirmation Procedure

Perform the following procedures in order. If the failure is duplicated, the confirmation procedure is completed.

• Procedure 1
  • Turn the vehicle to the ON mode.
  • Select the HDS [Function Test].
  • If the test result is not OK, the failure is duplicated.NOTE:  Perform the procedure with the HDS [Fuel Level] is below 85 %.

• Procedure 2
  • Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on.
  • Turn the vehicle to the OFF (LOCK) mode and leave the vehicle for at least 6 hours.
  • Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on.
  • Let it idle for at least 5 minutes 45 seconds.
  • Drive the vehicle at 25 mph (40 km/h) or more under light load only.
  • Stop the vehicle and leave the engine running for at least 200 milliseconds.

• When you have difficulty duplicating the DTC because of road conditions and traffic situations, repeat the driving pattern several times.