Multi View Camera Picture Inspection: Inspection

How to use this manual .

NOTE: 

• Before doing the multi view camera picture inspection, a person or an object equivalent to the driver must be placed in the driver's seat.
• A multi view camera aiming and picture inspection must be done whenever these items were removed / replaced or adjusted:
  • Power mirror
  • Front door
  • Tailgate
  • Front bumper or front grille
  • Camera (all)

You must perform the camera aiming first, before performing the picture inspection.

Before Inspection:

• Make sure the vehicle does not have an aftermarket suspension.
• Remove all cargo from the vehicle except the tool kit and the spare tire.
• Make sure all the tires are the correct size and set their pressures to the specifications shown on the doorjamb label.
• Clean the lens surface of each camera.
• All wheels of the vehicle should touch the ground.
• Make sure the steering wheel is pointed straight ahead and do not turn it after parking the vehicle.
• Shift the transmission to P position/mode, apply the parking brake.
• Make sure the front grille, the front bumper and the power mirrors are installed correctly.

NOTE:  When marking on the floor surface, use suitable tape to mark the exact locations.

1. Multi View Camera Picture - Inspect

   Preconditions 

   • Transmission P Position/Mode
   • Parking Brake Applied
   • HDS Connected

   Procedure 

   1. Select the following menu buttons on the HDS screen in sequence.

   1. Driving Support (System Selection Menu)
   2. Multi View Camera System
   3. Function Test
   4. Aiming Accuracy Checking Mode

   2. The multi view camera picture inspection can be performed using the mask sheet.

   NOTE: Although some amount of deviation in the picture might be present due to the number of passengers and the vehicle's loaded state, it is not a malfunction with the system.

   Place the mask sheets as shown:

   • Front camera: Placed on the left-front and right-front.
   • Rearview camera: Placed on the left-rear and right-rear.
   • Left side camera: Placed on the left-front and left-rear.
   • Right side camera: Placed on the right-front and right-rear.

   Courtesy of HONDA, U.S.A., INC.

   Distance Between Body and Mask Sheet 

   Position		Specifications
   a		400 mm (15.75 in)
   b	Mirrors closed	1200 mm (47.24 in)
   	Mirrors open	750 mm (29.53 in)
   c		650 mm (25.59 in)

   Normal Condition 

   Specifications
   Deviation within half of each other (as shown on the center display)

   3. Press ENTER on the HDS to exit the aiming accuracy checking mode.

   Result 

   • If it is abnormal, aim the multi view camera - Refer to: Multi View Camera Aiming ()  or Multi View Camera Picture Inspection () .