DTC P00B6: Inspection
Connector Visual Inspection
Test Procedure
- Procedure
- Check the connectors for a secure connection or for loose terminals at the following components:
* ECT sensor 2
* ECT sensor 1
* MAF sensor/IAT sensor
- Check the connectors for a secure connection or for loose terminals at the following components:
- Normal Conditions
- Conditions at the connections and terminals are OK.
Results
- If it is abnormal, there is a problem with the connections or terminals.
ECT sensor 2 Inspection
Test Procedure
- Preparation
- ECT sensor 2: removed and cooled to the ambient temperature
- Procedure
- Note the ambient temperature.
- Connect the ECT sensor 2 connector (2P), but do not install ECT sensor 2.
- Turn the vehicle to the ON mode.
- Confirm the HDS [ECT Sensor 2].
- Normal Conditions
- HDS [ECT Sensor 2] is almost the same as the ambient temperature.
Results
- If it is abnormal, there is a problem with ECT sensor 2.