Engine Oil Jet Inspection: Inspection

How to use this service information .

1. Oil Jet - Inspect

   Preconditions 

   • Oil Jet Removed

   Courtesy of HONDA, U.S.A., INC.

   Procedure/Specifications 

   1. Make sure that a 1.0 mm (3/64 in) diameter pin will go through the nozzle hole (a).

   Specifications 

   Specification/Standard Value (New)
   a	1.2 mm (0.047 in)
   	Nozzle not damaged or bent

   2. Make sure that a 1.0 mm (3/64 in) diameter pin will go through the oil intake (b).

   Specifications 

   Standard Value (New)
   b	1.2 mm (0.047 in)

   Specifications 

   Specification/Standard Value (New)
   c	Check ball moves smoothly

   3. Check the oil jet operation with an air nozzle.

   Specifications 

   Specification
   Should take at least 200 kPa (2.04 kgf/cm 2, 29.0 psi) to unseat the check ball.

   Result 

   • If it is abnormal, replace the oil jet.