DTC P2711
DTC P2711 : Unexpected Mechanical Gear Disengagement
NOTE:
- Before you troubleshoot, review the General Troubleshooting Information .
- This code can be caused if the parking lock is released by using the tool and the vehicle is turned to the ON mode.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P2711 Unexpected Mechanical Gear Disengagement |
DTC (A/T)
- Problem verification
- 1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Start the engine in P position/mode while pressing the brake pedal.
- 4. Turn the vehicle to the OFF (LOCK) mode, and wait for at least 10 seconds.
- 5. Start the engine in P position/mode while pressing the brake pedal again and wait for at least 1 second.
- 6. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P2711 Unexpected Mechanical Gear Disengagement Is DTC P2711 indicated?
YES
The failure is duplicated. Replace the hydraulic control unit .
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.