DTC P073E
DTC P073E : Unable to Engage Reverse
- Before you troubleshoot, review the General Troubleshooting Information .
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P073E Unable to Engage Reverse |
DTC (A/T)
- Problem verification
- 1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Start the engine.
- 4. While pressing the brake pedal, shift the transmission to R position/mode, then shift to P position/mode, and repeat this procedure twice.
- 5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P073E Unable to Engage Reverse Is DTC P073E indicated?
YES
The failure is duplicated. Replace the transmission - Refer to: Automatic Transmission Removal and Installation(9-Speed A/T), or Automatic Transmission Removal and Installation(6-Speed A/T) .
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals at the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.