DTC C1000-94
ElectronicCircuitSchematics-buttonADInfo-button DTC Advanced Diagnostics: VSA related DTCs SystemDescription-button OverviewDTC C1000-94 : ABS/VSA Activation Time Too Long
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- A wheel bearing that is installed backwards can cause this DTC.
| DTC Description | DTC |
|---|---|
| C1000-94 ABS/VSA Activation Time Too Long |
DTCs (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then start the engine.
Test-drive the vehicle at 19 mph (30km/h) or more for 30 seconds or more under these conditions:
- Accelerator pedal pressed
- Brake pedal released
NOTE: Drive the vehicle on the road, not on a lift.-5. Check for DTCs with the HDS.
DTC Description DTC C1000-94 ABS/VSA Activation Time Too Long Is DTC C1000-94 indicated?
YES
Check for loose terminals and poor connections in the VSA modulator-control unit 38P connector. If they are OK, replace the VSA modulator-control unit .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .