DTC P1658

DTC P1658  : ETCS Control Relay ON Malfunction

DTC (PGM-FI)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Select the ETCS TEST in the Function Test Menu with the HDS.

   ETCS TEST

   Is the RELAY circuit OK?

   YES 

   Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the relay circuit board and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .

   NO 

   Go to step 2.

2. Relay circuit board check

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Remove and test the relay circuit board .

   Is the relay circuit board OK?

   YES 

   Go to step 3.

   NO 

   Replace the relay circuit board .

3. Shorted wire check (DBW RLY CL- line)

   -1. Jump the SCS line with the HDS, and wait more than 1 minute.

   -2. Disconnect the following connector.

   PCM connector A (50P)

   -3. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Relay circuit board: removed
   	PCM connector A (50P): disconnected
   Test point 1	PCM connector A (50P) No. 25
   Test point 2	Body ground

   Is there continuity?

   YES 

   Repair a short in the DBW RLY CL- wire between the PCM (A25) and the relay circuit board.

   NO 

   Go to step 4.

4. Shorted wire check (DBW RLY OUT line to power)

   -1. Exit the SCS mode with the HDS.

   -2. Turn the vehicle to the ON mode.

   -3. Measure the voltage between test points 1 and 2.

   Test condition	Vehicle ON mode
   	Relay circuit board: removed
   	PCM connector A (50P): disconnected
   Test point 1	PCM connector A (50P) No. 16
   Test point 2	Body ground

   Is there battery voltage?

   YES 

   Repair a short to power in the DBW RLY OUT wire between the PCM (A16) and the relay circuit board.

   NO 

   The DBW RLY OUT wire is OK. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM , then recheck. If DTC P1658 goes away and the PCM was substituted, replace the original PCM .