Anti-Theft Feature

The audio-navigation unit has an anti-theft protection circuit. When one of the following occurs, the unit enters the anti-theft mode:

• Disconnecting the 12 volt battery.
• Disconnecting audio-navigation unit connector A (24P).
• Removing the No. B1-1 fuse, the No. B19 fuse or the No. D5 fuse.

After the service, reconnect power to the audio-navigation unit, and turn the vehicle to the ON mode. There are two ways to exit the anti-theft mode:

• Press and hold the VOLUME/POWER ( ) knob for at least 2 seconds. The audio-navigation unit automatically exits the anti-theft mode. If the audio-navigation unit does not exit anti-theft mode, turn the vehicle to the OFF (LOCK) mode then the ON mode (if possible, restart the READY TO DRIVE mode), and try to release the anti-theft several times.
• Enter the 5-digit anti-theft code. If the input of code fails 10 times in a row, the screen is locked for 60 minutes.

If the code is unavailable, you can get the code from the iN using the audio-navigation unit serial number. The serial number can be found on a label attached to the audio-navigation unit.

When the audio-navigation unit is installed in another vehicle (same Year/Model/Trim), like in cases where a known-good unit was substituted for testing, do the Anti-Theft Skip mode in the System Diagnostic Mode . This mode will release the anti-theft code for 150 seconds.