| Cannot select ON mode with keyless access and with the keyless remote touching the engine start/stop switch |
Symptom Troubleshooting |
- Check the No. A26
, No. B1-3
, No. B1-5
, No. B1-6
, No. B10
, and No. C3
fuses
- Poor connections at the keyless access/TPMS control unit
- Keyless remote
- Keyless access/TPMS control unit
- Electric steering lock*
- Engine start/stop switch
- Harness/connections
|
| Cannot select ON mode with keyless access, but can select ON mode with the keyless remote touching the engine start/stop switch |
Symptom Troubleshooting |
|
| Cannot select ON mode with the keyless remote touching the engine start/stop switch, but can select ON mode with keyless access |
Check the keyless access/TPMS control unit |
- Keyless access/TPMS control unit is not registered
- Keyless access/TPMS control unit
- MTR CONT line power short*
- ESLID mismatch*
- MTR CONT line open/short*
- IGN TRX line open/short
- Not registered
- Harness/connections
|
| The mode changes between ACC and ON, but it does not change to OFF |
- Check the keyless access/TPMS control unit
- Check the park pin switch
- Check the TCM *3
- Check the transmission range switch *2
|
- Keyless access/TPMS control unit
- ATP-P line open
- TCM
|
| The mode changes between ACC and ON, but it is difficult to change to OFF |
- Check the keyless access/TPMS control unit
- Check the gauge control module
- Check the park pin switch *2
|
- Gauge control module
- Keyless access/TPMS control unit
- PCM
- B-CAN communication line open/short
- F-CAN communication line open/short
- Speed signal line open
|
| Engine start/stop switch does not work |
Check for DTCs. If any DTC is indicated, go to the DTC troubleshooting |
- ACC relay circuit
- Keyless access/TPMS control unit
- Engine start/stop switch
- SS1+ line short
- SS2- line short
- Harness
|