Engine Mechanical - Testing & Troubleshooting
- Component Location Index
- General Information
- Connector View
- Check
- Learning Reset Clear
- Removal Installation & Inspection
- How to Information
- Test
- Adjustment
- Inspection
- Rewrite
- General Servicing
- Symptom Troubleshooting Index for Viewer
- After warming up, idle speed is above specifications without load (MIL works OK, no DTCs set) (KA, KC model)
- After warming up, idle speed is below specifications without load (MIL works OK, no DTCs set) (KA, KC model)
- Cold fast idle too high (MIL works OK, no DTCs set) (KA, KC model)
- Cold fast idle too low (MIL works OK, no DTCs set) (KA, KC model)
- Difficult to refuel (MIL works OK, no DTCs set) (KA, KC model)
- Engine is hard to start (MIL works OK, no DTCs set) (KA, KC model)
- Engine stalls (MIL works OK, no DTCs set) (KA, KC model)
- Engine starts but stalls immediately (MIL works OK, no DTCs set, immobilizer indicator stays on or flashes) (KA, KC model)
- Engine will not start (MIL works OK, no DTCs set, generator motor works OK) (KA, KC model)
- Engine will not start, and HDS does not communicate with the PCM (MIL comes on and stays on, no DTCs set) (KA, KC model)
- HDS does not communicate with the PCM or the vehicle (KA, KC model)
- Idle speed fluctuates (MIL works OK, no DTCs set) (KA, KC model)
- Low power (MIL works OK, no DTCs set) (KA, KC model)
- MIL comes on and stays on, or never comes on at all, no DTCs set (KA, KC model)
- Description & Operation
- Troubleshooting