TPMS Calibration Procedure
The calibration begins when TPMS switch is pressed. The calibration is completed after driving at 31 to 62 mph (50 to 100 km/h), steadily without much acceleration or deceleration, for about 18 minutes. Full functionality of the system cannot be performed properly if the calibration is not completed.
- Make sure the tires are inflated to the specified tire pressure listed on the doorjamb label.
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.NOTE: Vehicle must be stopped with the transmission in neutral (M/T) or P or N (A/T, CVT).
- Press the TPMS switch (A) for 3 seconds. See Fig 1.
- When the calibration successfully begins, the indicator (B) blinks twice.NOTE: If the indicator does not blink, check the TPMS switch.
- The calibration process finishes automatically. It requires approximately 30 minutes of cumulative driving at speeds between 30-60 mph (48-97 km/h).NOTE: During this period, if the ignition is turned on and the vehicle is not moved within 45 seconds, you may notice the low tire pressure/TPMS indicator comes on briefly. This is normal and indicates that the calibration process is not yet complete.
- See Calibration Completion Check.
NOTE:
The calibration check process will be interrupted if the vehicle moves. If the indicator does not go off after 2 seconds, keeps blinking, or stays on when the vehicle is in the ON mode, see appropriate manufacturer service information.