LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2016 >> Odyssey EX >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio System >> Audio Display Visor Removal/Installation

Audio Display Visor Removal/Installation

NOTE:
  • Do this procedure in a clean place free from dirt.
  • Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).
  • When removing the audio display visor, do not touch the LCD facing.
  • If there is dirt on the LCD facing, clean it using compressed air.
  • When installing the audio display visor onto the LCD assembly, be careful not to touch the LCD facing.
  • Check that the audio display visor and the LCD assembly are properly installed.
  • Since the LCD assembly and the audio display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.
  • Check that the audio display unit assembly has no damage.
  • When removing the audio display visor, do not hold the LCD facing down.
  1. Remove the audio display-USB adapter control unit (see AUDIO DISPLAY-USB ADAPTER CONTROL UNIT REMOVAL/INSTALLATION  ).
  2. Remove the screws and the LCD assembly (A) from the audio display visor (B).
    Fig 1: Locating LCD Assembly And Audio Display Visor
    G06970913Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the audio display visor reverse order of removal.
scientia non olet · About LEMON Manuals