LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2015 >> Pilot Touring, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio System >> Symptom Troubleshooting >> Audio switch panel button dos not work properly

Audio switch panel button dos not work properly

NOTE:
  • Check the vehicle battery condition first (see BATTERY TEST ).
  • Check the connectors for poor connections or loose terminals.
  1. Turn the ignition switch to ON (II).
  2. Check the audio switch panel button and interface dial operation.

    Is the audio switch panel operation OK? 

    YES  -Intermittent failure, the system is OK at this time.

    NO  -Go to step 3.

  3. Turn the ignition switch to LOCK (0).
  4. Check the No. 35 (10 A) fuse in the under-dash fuse/relay box.

    Is the fuse OK? 

    YES  -Go to step 5.

    NO  -Replace the fuse, and recheck. If the fuse blows again, check for a short in the No. 35 (10 A) fuse circuits.

  5. Turn the ignition switch to ON (II).
  6. Measure the voltage between audio switch panel 12P connector terminals No. 2 and No. 4.
    Fig 1: Measuring Voltage Between Audio Switch Panel 12P Connector Terminals No. 2 And 4
    G08090811Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there battery voltage? 

    YES  -Go to step  8.

    NO  -Go to step 7.

  7. Measure the voltage between audio switch panel 12P connector terminals No. 2 and body ground.
    Fig 2: Measuring Voltage Between Audio Switch Panel 12P Connector Terminals No. 2 And Body Ground
    G08090812Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there battery voltage? 

    YES  -Repair an open or high resistance in the wire between the audio switch panel 12P connector terminal No. 4 and body ground (G403) (see CONNECTOR TO FUSE/RELAY BOX INDEX ).

    NO  -Repair an open in the wire between the under-dash fuse/relay box and the audio switch panel 12P connector terminal No. 1.

  8. Turn the ignition switch to LOCK (0).
  9. Disconnect audio unit connectors E (16P) and the audio switch panel 12P connector.
  10. Check for continuity between body ground and audio switch panel 12P connector according to the table.
    Audio switch panel connector Wire color
    No. 5 PNK
    No. 6 ORN
    No. 10 BLK
    No. 11 BLU
    No. 12 LT GRN
    Fig 3: Checking Continuity Between Body Ground And Audio Switch Panel 12P Connector
    G08090813Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Repair a short to body ground in the wire(s) between the audio unit and the audio switch panel.

    NO  -Go to step 11.

  11. Check for continuity between audio switch panel 12P connector according to the table.
    Audio switch panel connector Audio unit connector Wire color
    No. 5 E8 PNK
    No. 6 E7 ORN
    No. 10 E4 BLK
    No. 11 E2 BLU
    No. 12 E10 LT GRN
    Fig 4: Checking Continuity Between Audio Switch Panel 12P Connector Terminals
    G08090814Courtesy of AMERICAN HONDA MOTOR CO., INC.
    Fig 5: Checking Continuity Between Audio Unit Connector E (16P) Terminals
    G08090815Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Substitute a known-good audio switch panel (see AUDIO SWITCH PANEL REMOVAL/INSTALLATION  ), and recheck. If the symptom/indication goes away, replace the original audio switch panel. If the symptom/indication is still present, replace the audio unit.

    NO  -Repair an open in the wire(s) between the audio unit and the audio switch panel.