LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2015 >> Pilot Touring, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (PGM-FI System) >> ELD Replacement

ELD Replacement

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the under-hood fuse/relay box (see REMOVAL AND INSTALLATION ).
  2. Remove the screws (A), and the fuse (B).
    Fig 1: Identifying Fuse & Screws
    G05969711Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Turn the housing over, then remove the screw (A).
    Fig 2: Identifying ELD Screw
    G05969712Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Turn the housing over again. Using two flat-tip screwdrivers, release the tabs (A), and pry up the fuse/relay box base (B) from the fuse/relay box housing (C).
    NOTE: Make sure the terminals (D) are not bent or damaged.
    Fig 3: Identifying Fuse/Relay Box Base & Housing
    G05969713Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the ELD (A).
    Fig 4: Identifying ELD
    G05969714Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the parts in the reverse order of removal.
scientia non olet · About LEMON Manuals