LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2015 >> Pilot LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (VSA (Vehicle Stability Assist) System Components) >> Wheel Speed Sensor Replacement >> Front

Wheel Speed Sensor Replacement: Front

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Release the clamp (A), then disconnect the wheel speed sensor connector (B).
    Fig 1: Clamp, Wheel Speed Sensor Connector, Wheel Speed Sensor & Bolts (Front) With Torque Specifications
    G05963006Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the bolts and the wheel speed sensor (C).
  4. Install the wheel speed sensor in the reverse order of removal, and note these items:
    • Install the sensor carefully to avoid twisting the wires.
    • If the wheel speed sensor comes in contact with the hub bearing unit, it is faulty.
  5. Start the engine, and make sure the ABS and the VSA indicators go off.
  6. Test-drive the vehicle, and make sure the ABS and the VSA indicators do not come on.
scientia non olet · About LEMON Manuals