LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2015 >> Pilot LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (VSA (Vehicle Stability Assist) System Components) >> VSA Modulator-Control Unit Removal and Installation >> Removal

VSA Modulator-Control Unit Removal and Installation: Removal

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Remove the air cleaner (see AIR CLEANER REMOVAL/INSTALLATION ).
  3. Remove the resonator (see INTAKE AIR RESONATOR REMOVAL/INSTALLATION ).
  4. Disconnect the VSA modulator-control unit 36P connector (A) by pushing the lock (B) and pulling down the lever (C); the connector disconnects itself.
    Fig 1: VSA Modulator-Control Unit Components With Torque Specifications
    G05963005Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Disconnect the six brake lines from the VSA modulator-control unit.
    NOTE: Brake lines are connected to the master cylinder (D) and to the left-rear (E), the right-front (F), the left-front (G), and the right-rear (H) brake systems.
  6. Remove the VSA modulator-control unit (I) with the bracket (J) from the body.
  7. Remove the VSA modulator-control unit from the bracket.
scientia non olet · About LEMON Manuals