Neutral Position Switch Replacement

Remove the air cleaner (see AIR CLEANER ELEMENT INSPECTION/REPLACEMENT ).
Disconnect the neutral position switch 2P connector' (A).

Fig 1: Identifying Neutral Position Switch 2P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the neutral position switch (A).

Fig 2: Neutral Position Switch With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Apply liquid gasket (P/N 08718-0001, 08718-0003, or 08718-0004) evenly to the threads of the neutral position switch, and install it on the change lever assembly. Install the component within 5 minutes of applying the liquid gasket.
NOTE: If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
Connect the neutral position switch 2P connector.
Install the air cleaner (see AIR CLEANER ELEMENT INSPECTION/REPLACEMENT ).