DTC P154A: Battery Sensor Internal Failure
NOTE: Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the Fuel and Emissions SystemsHow to Troubleshoot the CVT System(CVT System) .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P154A Battery Sensor Internal Failure |
DTC (PGM-FI)
- 1. Problem verification:
- 1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS, and wait 5 seconds.
- 3. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P154A Battery Sensor Internal Failure Is DTC P154A indicated?
YES
The failure is duplicated. Replace the 12 volt battery sensor .
NO
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the 12 volt battery sensor, the alternator, and the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.