Selector Control Shaft Bearing Replacement

Special Tools Required 

• Bearing Remover, 10 mm 07936-GE0A000
• Slide Hammer 07936-371020A
• Driver Handle, 15 x 135L 07749-0010000
• Attachment, 22 x 24 mm 07746-001A800

1. Remove the control shaft bearing from the transmission housing using the 10 mm bearing remover head, the 10 mm bearing remover shaft, and the slide hammer.
   Fig 1: Removing Control Shaft Bearing From Transmission Housing Using Slide Hammer

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing in the transmission housing using the driver handle and the 22 x 24 mm attachment.
   Fig 2: Identifying Bearing And Driver Handle

   Courtesy of AMERICAN HONDA MOTOR CO., INC.