Without ATF Cooler

Fig 1: Identifying ATF Cooler Hose Clamps (Without ATF Cooler)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

NOTE: When installing the hose clamps, make sure they do not interfere with the surrounding parts.

Install the ATF cooler hoses over the ATF cooler lines with the clips at the appropriate points in reference to the following list.

With ATF cooler: Align the paint mark (I) upward.

Point	Distance from Hose End to Clip (H)	Hose End Contact Point
A	2-4 mm (0.08-0.16 in)	Bulge
B	2-4 mm (0.08-0.16 in)	Bulge
C	6-8 mm (0.24-0.31 in)	Bulge
D
E
F
G

Secure the hose with the clip (G), aligning the tab (J) upward.
With ATF cooler: Secure the ATF cooler hose with the clamps (K) at the marking (L).
Refill the transmission with ATF to the proper level (see step 6 under ATF Replacement ).