DTC P0116: ECT Sensor 1 Circuit Range/Performance Problem

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

Turn the ignition switch to ON (II).
Check ECT SENSOR 1 in the DATA LIST with the HDS.
Is about 176°F (80°C) or more, or 0.78 V or less indicated?

YES -Go to step 6.

NO -Go to step 3.
Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
Start the engine. Hold the engine speed at 3, 000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
Check ECT SENSOR 1 in the DATA LIST with the HDS.
Does ECT SENSOR 1 change 18°F (10°C) or more?

YES -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the PCM. ■

NO -Go to step 11.
Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
Turn the ignition switch to LOCK (0).
Open the hood, and let the engine cool for 3 hours.
Turn the ignition switch to ON (II).
Check ECT SENSOR 1 in the DATA LIST with the HDS.
Does ECT SENSOR 1 change 18°F (10°C) or more?

YES -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the PCM. ■

NO -Go to step 11.
Turn the ignition switch to LOCK (0).
Replace ECT sensor 1 (see ECT SENSOR 1 REPLACEMENT ).
Turn the ignition switch to ON (II).
Reset the PCM with the HDS.
Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
Check for Pending DTCs or Confirmed DTCs with the HDS.
Is DTC P0116 indicated?

YES -Check for poor connections or loose terminals at ECT sensor 1 and the PCM, then Go to step 1.

NO -Troubleshooting is complete. If any other Pending DTCs or Confirmed DTCs are indicated, Go to the indicated DTC's troubleshooting. ■