Power Mirror Replacement

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the door and related parts.

Lower the door glass fully.
Carefully detach the clip, and release the hooks (A), then pry out the mirror mount cover (B) by hand in the sequence shown.

Fig 1: Identifying Mirror Mount Cover And Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
While holding the mirror, disconnect the connector (A), then remove the nuts.

Fig 2: Connector And Nuts With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
While holding the mirror, squeeze the sides of connector clip (A), then push out to remove the mirror (B). Take care not to scratch the door.

Fig 3: Identifying Connector Clip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the mirror in the reverse order of removal, and note these items:
- Make sure the connector is plugged in properly.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the connector clip into place securely.