Windshield Wiper Motor Replacement: Installation

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Before installing the motor, connect the 5P connector to the wiper motor, and turn the wiper/washer switch ON to (LO) or (HI) position, then OFF to return the motor shaft to the park position.
NOTE:
- Do not use the wiper/washer switch (INT) position in this step.
- If necessary, replace any damaged clips.
- Apply multipurpose grease to the moving parts.
Install the wiper motor to the wiper linkage assembly in the reverse order of removal.
Install the link to the wiper motor shaft, then align the mark (A) of the link and the mark (B) of the wiper linkage assembly.

Fig 1: Aligning Mark Of Link & Mark Of Wiper Linkage Assembly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
After installation, adjust the wiper arms (see WIPER ARM/NOZZLE ADJUSTMENT ).