VTM-4 LOCK Switch Test/Replacement

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Remove the Driver's center panel (see DASHBOARD CENTER PANEL REMOVAL/INSTALLATION ).
Disconnect the VTM-4 LOCK switch 5P connector from the VTM-4 LOCK switch (A), then remove the VTM-4 LOCK switch from the driver's center panel (B).

Fig 1: Identifying VTM-4 Lock Switch 5P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each button position according to the table below.

Fig 2: Identifying Terminals Continuity Table
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity check is not as specified, replace the VTM-4 LOCK switch bulb or the VTM-4 LOCK switch.