LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2014 >> Pilot EX, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Automatic Transmission) >> Input Shaft (Mainshaft) Speed Sensor Replacement

Input Shaft (Mainshaft) Speed Sensor Replacement

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a lift, or apply the parking brake, block both rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
  2. Remove the splash shield (A).
    Fig 1: Identifying Splash Shield
    G05961757Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the damper from the front subframe.
    Fig 2: Damper & Front Subframe Bolts With Torque Specifications
    G05961758Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).
    Fig 3: O-Ring On Input Shaft (Mainshaft) Speed Sensor With Torque Specifications
    G05961759Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the new O-ring (B) on the new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor in the transmission housing.
  6. Check the connector for rust, dirt, or oil, and clean if necessary, then connect it securely.
  7. Install the damper on the front subframe.
  8. Install the splash shield.
scientia non olet · About LEMON Manuals