LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2014 >> Pilot EX, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Automatic Transmission) >> Input Shaft (Mainshaft) Speed Sensor Replacement

Input Shaft (Mainshaft) Speed Sensor Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the splash shield.
  2. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).
    Fig 1: Input Shaft (Mainshaft) Speed Sensor And O-Ring With Torque Specifications
    G06628752Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install a new O-ring (B) on a new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor in the transmission housing.
  4. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
  5. Install the splash shield.
scientia non olet · About LEMON Manuals