LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2014 >> Pilot EX, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Automatic Transmission) >> ATF Cooler Replacement

ATF Cooler Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bulkhead cover (see FRONT BULKHEAD COVER REPLACEMENT ).
  2. Remove the front bumper (see FRONT BUMPER REMOVAL/INSTALLATION ).
  3. Disconnect the ATF cooler hoses (A) from the ATF cooler lines.
    Fig 1: Identifying ATF Cooler Hoses, Splash Shield With ATF Cooler And Cooler Hoses Assembly
    G06628870Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the splash shield (B), and remove the ATF cooler and cooler hoses assembly (C).
  5. Install a new ATF cooler and cooler hoses assembly.
  6. Slide the cooler hoses (A) over the ATF cooler lines (B) until the hose ends (C) contact with the bulge (D), and secure the hoses with the clips (E) at 6-8 mm (0.2- 0.3 in) (F) from the hose end.
    Fig 2: Identifying Cooler Hoses, ATF Cooler Lines, Hose Ends With Bulge
    G06628871Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Make sure that the hose clamp (G) is installed at the mark(H).
  8. Install the splash shield on the bulkhead bracket.
  9. Install the bumper (see FRONT BUMPER REMOVAL/INSTALLATION ).
  10. Install the bulkhead cover (see FRONT BULKHEAD COVER REPLACEMENT ).
scientia non olet · About LEMON Manuals