Idle Speed Inspection

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before checking the idle speed, check these items:
- The malfunction indicator lamp (MIL) has not been reported on, and there are no DTCs.
- Ignition timing
- Spark plugs
- Air cleaner
- PCV system
Apply the parking brake.

Disconnect the evaporative emission (EVAP) canister purge valve connector.
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

Fig 1: Identifying Data Link Connector (DLC)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Start the engine. Hold the engine speed at 3, 000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
Check the idle speed under no load conditions: headlights, blower fan, radiator fan, audio system, and air conditioner off.
Idle speed should be:

720 ± 50 rpm (in P or N)
Let the engine idle for 1 minute with high electric load (A/C switch ON, temperature set to Max Cool, blower fan on High, and headlights on high beam).
Idle speed should be:

720 ± 50 rpm (in P or N)

NOTE: If the idle speed is not within specification, do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ). If the idle speed is still not within specification, go to symptom troubleshooting.
Reconnect the EVAP canister purge valve connector.