Alternator Removal and Installation: Removal

Remove the air intake duct (see step 1 under FRONT BULKHEAD COVER REPLACEMENT ).
Do the battery terminal disconnection procedure (see USING THE GR8 BATTERY DIAGNOSTIC STATION ).
Remove the engine cover (see step 1 under REMOVAL ).
Remove the coolant reservoir (A) and the power steering fluid reservoir (B), then remove the holder bracket (C).

Fig 1: Identifying Coolant Reservoir, Power Steering Fluid Reservoir And Holder Bracket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the drive belt (see DRIVE BELT REPLACEMENT ).
Disconnect the alternator connector (A) and the positive alternator cable (B) from the alternator.

Fig 2: Identifying Alternator Connector, Alternator Cable A/C Compressor Clutch Connector And A/C Compressor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the A/C compressor clutch connector (C) from the A/C compressor.
Remove the bolt (D) securing the harness holder.
Remove the mounting bolt (A) and the alternator bracket mounting bolt (B), then remove the alternator (C).

Fig 3: Identifying Mounting Bolt, Alternator Bracket Mounting Bolt And Alternator
Courtesy of AMERICAN HONDA MOTOR CO., INC.