Keyless Access System Registration: Procedure
NOTE: If you replace the body control module or steering lock, the vehicle will not turn to the ON mode. Follow the registration procedure of the corresponding unit.
- Keyless Access System - Register
NOTE:
- Check for aftermarket electrical equipment that could cause problems with keyless access operation.
- While doing the registration, keep the remote away from computers.
- Programming the remote also programs the keyless transmitter.
- The body control module can store codes up to 6 remotes.
- When each unit is replaced, such as updating and learning may be necessary in some cases, also make sure the removal and installation procedure of each unit.
When Replacing the Body Control Module or the Electric Steering Lock Control Unit
1. Connect the HDS to the data link connector (DLC)
2. Do the registration according to the "Immobilizer Setup Tool" screen.
3. After registration, verify all remote related systems work normally with all remotes.
When Replacing the TCM (Without Electric Steering Lock)
1. Connect the HDS to the data link connector (DLC)
2. Do the registration according to the instructions on the HDS screen.
3. After registration, verify all remote related systems work normally with all remotes, then do the procedure after replacing the TCM:
When Replacing the PCM, the VSA Modulator-Control Unit, the Telematics Control Unit, or Registration of the Remote (s)
NOTE: If you are replacing the body control module, register the body control module first.
1. Connect the HDS to the data link connector (DLC)
2. When all remotes are lost, select "Immobilizer Setup Tool", and turn the vehicle to ON mode according to the instructions on the HDS screen, then go to step 5.
3. Turn the vehicle to the ON mode.
4. Select "Immobilizer Setup Tool".
5. Select the appropriate items, and do the registration according to the instructions on the HDS screen.
6. After registration, verify systems work normally with all remotes.