Blower Resistor Test

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the 4P connector (A) from the blower resistor.

Fig 1: Identifying Blower Resistor 4P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Measure the resistance between the following terminals of the blower resistor, and compare them with the values in the table below.

Fig 2: Identifying Switch Position Table
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 3: Measuring Resistance Between Blower Resistor Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the resistance is not within the specifications, replace the blower resistor.