Specifications Index
CR-V COMMON SPECS & PROCEDURES INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | AIR CONDITIONING SYSTEM | ||
| Torque | See applicable component in A/C Compressor Relief Valve Removal and Installation article. | ||
| Axle Nut/Hub Nut | |||
| Front | 328 N.m (242 ft. lbs.) | ||
| Rear | 181 N.m (133 ft. lbs.) | ||
| Battery | Battery Removal and Installation | ||
| Brakes | |||
| Bleeding Sequence | Brake System Bleeding | ||
| Disc Brakes | See applicable component in BRAKES article. | ||
| Torque | See applicable component in Torque Specifications article. | ||
| Charging | |||
| Generator | Charging System Component Location Index & Drive Belt Routing | ||
| Torque | See applicable figure in Installation . | ||
| Drive Belts | |||
| Adjustment | Inspection | ||
| Belt Routing | Installation | ||
| Engine Cooling | |||
| General Service Specifications | See applicable component in ENGINE SERVICE SPECIFICATIONS - CR-V | ||
| Radiator Cap Pressure | 93-123 kPa (0.95-1.25 kgf/cm2 , 13.5-17.8 psi) | ||
| Thermostat R & I | Thermostat Removal, Installation, and Test | ||
| Water Pump R & I | Water Pump Removal and Installation | ||
| Engine Mechanical | |||
| Compression | See applicable component in ENGINE SERVICE SPECIFICATIONS - CR-V | ||
| Oil Pressure (176°F (80°C) | 70 kPa (.71 kgf/cm2 , 10.1 psi) @ idle; 300 kPa (3.06 kgf/cm2 , 43.5 psi) @ 3000 RPM | ||
| Overhaul | See applicable specifications table in ENGINE SERVICE SPECIFICATIONS - CR-V . | ||
| Torque | See applicable component in one of the following articles: Installation Installation Engine Lubrication System Component Location Index Intake Air System and Exhaust System Component Location Index |
||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab.Lubricants and Fluids | ||
| Flywheel/Flex Plate Torque | 74 N.m (55 ft. lbs.) | ||
| Fuel System | |||
| Pressure Specification | 320-370 kPa (3.3-3.8 kgf/cm2 , 47-54 psi) | ||
| Fuel Pressure Test Procedure | Test | ||
| Ignition | |||
| Firing Order & Cylinder Identification | 4 CYLINDER ENGINE | ||
| Spark Plug NGK: ILZKR7B-11S; DENSO: SXU22HCR11S | |||
| Gap | 1.0-1.1 mm (.039-.043 in.) | ||
| Torque | 18 N.m (13 ft. lbs.) | ||
| Starting | |||
| Starter | Test | ||
| Torque | Installation | ||
| Wheel Alignment | |||
| Adjustment Specifications | Inspection | ||
| Torque | |||
| Front | See applicable component in Front Suspension article. | ||
| Rear | See applicable component in Rear Suspension article. | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 108 N.m (80 ft. lbs.) | ||