Immobilizer indicator does not go off or does not come on
- Keyless access system check 1
-1. Press the engine start/stop button to select the OFF mode.
- 2. Press the engine start/stop button to select the ON mode.
- 3. Check the immobilizer indicator.
Does the immobilizer indicator come on?
YES
Go to step 2.
NO
Go to step 5.
- Keyless access system check 2
-1. Check the immobilizer indicator.
Does the indicator come on, then go off?
YES
Go to step 3.
NO
Go to step 6.
- Keyless access system check 3
-1. With driver's power window open and all the doors closed, press the engine start/stop button to select the OFF mode.
- 2. Remove all the keyless remotes from inside the vehicle. Hold them outside the open driver's window, at least 8.0 in (20 cm) away from the vehicle.
- 3. Press the engine start/stop button. The MID should request the keyless remote to touch the engine start/stop button. The LED on the engine start/stop button will flash for up to 30 seconds.
- 4. Touch the engine start/stop switch with the keyless remote. The buttons on the keyless remote should be facing you. The LED on the engine start/stop button will turn solid when detected.
- 5. Press the engine start/stop button to select the ON mode.
- 6. Check the immobilizer indicator.
Does the indicator blink once, then stay off?
YES
Intermittent failure, the system is OK at this time.
NO
Go to step 4.
- Keyless access system check 4
-1. Select BACKUP CONTROL UNIT from the ONE-PUSH START system select menu with the HDS, and enter SYSTEM INFORMATION.
One-Push - BACKUP CONTROL UNIT - System Information
Perform the SYSTEM CHECK with the HDS.
Is N-1 OK indicated?
YES
Replace the gauge control module .
NO
Troubleshoot the keyless access system according to the result of the SYSTEM CHECK.
- PGM-FI system check
-1. Check the malfunction indicator lamp (MIL).
Does the indicator come on?
YES
Troubleshooting the PCM DTCs.
NO
- Keyless access system check 3
-1. Select KEYLESS ACCESS CONTROL UNIT from the ONE-PUSH START system select menu with HDS, and enter SMART INFORMATION.
One-Push - KEYLESS ACCESS CONTROL UNIT- Smart Information
Perform the SYSTEM CHECK 1 and 2 with the HDS.
Is N-1 OK indicated?
YES
Replace the gauge control module .
NO
Troubleshoot the keyless access system according to the result of the SYSTEM CHECK 1 and 2.