LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2014 >> Accord Plug-In >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System - Testing & Troubleshooting (Hybrid) >> Symptom Troubleshooting >> Navigation System Symptom Troubleshooting - Navigation Frequently Asks For Anti-Theft Code And/Or Needs GPS Initialization (2014 2015)

Navigation System Symptom Troubleshooting - Navigation Frequently Asks For Anti-Theft Code And/Or Needs GPS Initialization (2014 2015)

NOTE:
  • Check the 12 volt vehicle battery condition first .
  • This is often caused by a loss of battery power, a low or poor battery condition, or a poor ground.
  • Make sure that the latest navigation software is installed.
  • Check any official Honda service website for more service information about the navigation system.
  • Check the connectors for poor connections or loose terminals.
  1. Problem verification

    -1. Check if the CSF screen is displayed every time the power switch is turned to ON mode.

    Is CSF screen displayed every time?

    YES 

    The failure is duplicated, go to step 2.

    NO 

    Intermittent failure, the system is OK at this time.

  2. Open wire check (+B AUDIO line)

    -1. Turn the vehicle to the OFF (LOCK) mode.

    - 2. Measure the voltage between test points 1 and 2.

    Test condition Vehicle OFF (LOCK) mode
    Test circuit +B AUDIO
    Test point 1 Audio-Navigation unit connector A (24P) No. 3 (LT BLU)
    Test point 2 Body ground
    Test circuit +B AUDIO
    Test point 1 Audio-Navigation unit connector F (18P) No. 3 (LT BLU)
    Test point 2 Body ground
    GHH261385Courtesy of HONDA, U.S.A., INC.
    GHH261386Courtesy of HONDA, U.S.A., INC.

    Is there battery voltage?

    YES 

    The +B AUDIO wire is OK. Go to step 3.

    NO 

    Repair an open in the wire (s) between the No. 22 (15 A) fuse in the under-hood fuse/relay box and the audio-navigation unit.

  3. Open wire check (ACC line)

    -1. Turn the vehicle to the ON mode.

    - 2. Measure the voltage between test points 1 and 2.

    Test condition Vehicle ON mode
    Test circuit ACC
    Test point 1 Audio-Navigation unit connector A (24P) No. 24 (PUR)
    Test point 2 Body ground
    GHH261387Courtesy of HONDA, U.S.A., INC.

    Is there battery voltage?

    YES 

    The ACC wire is OK. Go to step 4.

    NO 

    Repair an open in the wire between the No. B37 (7.5 A) fuse in the under-dash fuse/relay box and the audio-navigation unit.

  4. Open wire check (GND lines)

    -1. Measure the voltage between test points 1 and 2.

    Test condition Vehicle ON mode.
    Test circuit GND
    Test point 1 Audio-Navigation unit connector A (24P) No. 1 (BLK)
    Test point 2 Body ground
    Test circuit GND
    Test point 1 Audio-Navigation unit connector F (18P) No. 1 (BRN)
    Test point 2 Body ground
    GHH261388Courtesy of HONDA, U.S.A., INC.
    GHH261389Courtesy of HONDA, U.S.A., INC.

    Is there less than 0.2 V?

    YES 

    Replace the audio-navigation unit - Refer to: Audio-Navigation Unit Removal and Installation (2014 2015), or Audio-Navigation Unit Removal and Installation (With Display Audio) (2017) .

    NO 

    Repair an open or high resistance in the wire (s) between the audio-navigation unit and body ground (G505) and/or (G506).