DTC 2610: DRAM Diag (2014-15)

NOTE: 

• First, check the Vehicle 12 volt battery condition .
• This navigation DTC sets when a problem with the internal DRAM is detected.
• Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Navigation System (2014-15) .
• Check any official Honda service website for more service information about the navigation system.

1. Problem verification

   -1. Clear the hard error codes.

   - 2. Turn the vehicle to the OFF (LOCK) mode, and then back to ON mode.

   - 3. Check for hard error codes.

   Is DTC 2610 indicated?

   YES 

   The failure is duplicated, go to step 2.

   NO 

   Intermittent failure, the system is OK at this time.

2. Determine possible failure area (audio-navigation unit, others)

   -1. Go into the System Diagnostic Mode, and select the Navi ECU in the System Links to check the D-RAM.

   Is D-RAM OK indicated?

   YES 

   Intermittent failure, the system is OK at this time.

   NO 

   Replace the audio-navigation unit - Refer to: Audio-Navigation Unit Removal and Installation (2014-15) .