DTC 2608: Rear Camera Diag (With Display Audio) (2017)

NOTE: 

• First, check the Vehicle 12 volt battery condition .
• This navigation DTC sets when NG is indicated in the Rear Wide Camera diagnosis (the Rear Wide Camera icon is red in the System Link).
• Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Navigation System (With Display Audio) (2017) .
• Check the connectors for poor connections or loose terminals.

1. Problem verification

   -1. Clear the hard error codes.

   - 2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.

   - 3. Check for hard error codes.

   Is DTC 2608 indicated?

   YES 

   The failure is duplicated, go to step 2.

   NO 

   Intermittent failure, the system is OK at this time.

2. Determine possible failure area (CAMERA ADPT line, others)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Disconnect the following connector.

   Rearview camera 8P connector

   - 3. Turn the vehicle to the ON mode.

   - 4. Measure the voltage between test points 1 and 2.

   Test condition	Vehicle ON mode
   	Rearview camera 8P connector: disconnected
   Test point 1	Rearview camera 8P connector No. 6 - Refer to: Rearview Camera Connector for Inputs and Outputs (With Display Audio) (2017)
   Test point 2	Body ground

   Is there about 3.0 V?

   YES 

   The CAMERA ADPT wire is OK. Go to step 4.

   NO 

   Go to step 3.

3. Open wire check (CAMERA ADPT line)

   -1. Measure the voltage between test points 1 and 2.

   Test condition	Vehicle ON mode
   	Rearview camera 8P connector: disconnected
   Test point 1	Audio-navigation unit connector C (24P) No. 19 - Refer to: Audio-Navigation Unit Connector for Inputs and Outputs (With Display Audio) (2017)
   Test point 2	Body ground

   Is there about 3.0 V?

   YES 

   Repair an open in the wire between the audio-navigation unit and the rearview camera.

   NO 

   Replace the audio-navigation unit - Refer to: Audio-Navigation Unit Removal and Installation (With Display Audio) (2017) .

4. Rearview camera check

   -1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Rearview camera 8P connector: disconnected

   Test point 1	Rearview camera 8P connector No. 1 - Refer to: Rearview Camera Connector for Inputs and Outputs (With Display Audio) (2017)
   Test point 2	Body ground

   Is there continuity?

   YES 

   Replace the rearview camera .

   NO 

   Go to step 5.

5. Open wire check (CAMERA V GND line)

   -1. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Rearview camera 8P connector: disconnected
   Test point 1	Audio-navigation unit connector C (24P) No. 4 - Refer to: Audio-Navigation Unit Connector for Inputs and Outputs (With Display Audio) (2017)
   Test point 2	Body ground

   Is there continuity?

   YES 

   There is an open in the wire between the audio-navigation unit and the rearview camera. Replace the affected shielded harness.

   NO 

   Replace the audio-navigation unit - Refer to: Audio-Navigation Unit Removal and Installation (With Display Audio) (2017) .