DTC B12D2: Power Control Unit IG2 Circuit Error

DTC (Power Control Unit)

NOTE: 

• If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: BODY ELECTRICAL TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A - INITIAL COMMUNICATION AND DTC CHECKS .
• Make sure aftermarket accessories are not installed.

1. Problem verification

   - 1. Clear the DTCs with the HDS.

   - 2. Turn the vehicle to the ON mode.

   - 3. Wait 10 seconds.

   - 4. Turn the vehicle to the OFF (LOCK) mode.

   - 5. Wait 5 seconds.

   - 6. Check for DTCs with the HDS.

   DTC Description	DTC
   B12D2: Power Control Unit IG2 Circuit Error

   Is DTC B12D2 indicated?

   YES 

   Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time.

2. Determine possible failure area (IG2 relay circuit ON problem, IG2 relay circuit OFF problem)

   - 1. Turn the vehicle to the ON mode.

   - 2. Check the parameter(s) below with the HDS.

   Signal	Current Conditions
   	Value	Unit
   IG2

   - 3. Check the IG2 with the HDS.

   Is there battery voltage?

   YES 

   Go to step 3.

   NO 

   Go to step 4.

3. Under-dash sub relay box test (IG2 relay circuit)

   - 1. Do the under-dash sub relay box test (IG2 relay circuit).

   Is IG1A relay circuit OK?

   YES 

   Repair a short to power in the wire.

   NO 

   Faulty IG2 relay circuit, REPLACE THE UNDER-DASH SUB RELAY BOX .

4. Under-dash sub relay box test (IG2 relay circuit)

   - 1. Do the under-dash sub relay box test (IG2 relay circuit).

   Is IG2 relay circuit OK?

   YES 

   Repair an open or high resistance in the wire.

   NO 

   Faulty IG2 relay circuit, REPLACE THE UNDER-DASH SUB RELAY BOX .