DTC P1129: MAP Sensor Signal Higher Than Expected
- Check for vacuum leaks in these parts:
- PCV valve
- PCV hose
- EVAP canister purge valve
- Throttle body
- Intake manifold
- Brake booster
- Brake booster hose
Are there any vacuum leaks?
YES -Repair or replace the part (s) with vacuum leaks, then go to step 9.
NO -Go to step 2.
- Start the engine. Hold the engine speed at 3, 000 RPM without load (CVT in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.
- Check the MAP SENSOR in the DATA LIST with the HDS.
Is more than 36.9 kPa (11.0 in.Hg, 277 mmHg), or 1.14 V held for more than for 5 seconds?
YES -Go to step 7.
NO -Go to step 4.
- Clear the DTC with the HDS.
- Test-drive under these conditions:
- Engine coolant temperature (ECT SENSOR 1) above 158°F (70°C)
- CVT in D, M/T in 5th
- Drive at a steady speed between 55-75 mph (90-120 km/h) for 10 seconds
- During the drive, decelerate (with the throttle fully closed) for at least 2 seconds
- Monitor the OBD STATUS for DTC P1129 in the DTCs MENU with the HDS.
Does the HDS indicate FAILED?
YES -Go to step 7.
NO -If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MAP sensor and the ECM/PCM. If the HDS indicates NOT COMPLETED, go to step 5 and recheck.
- Turn the ignition switch to LOCK (0).
- Replace the MAP sensor (see MAP SENSOR REPLACEMENT ).
- Turn the ignition switch to ON (II).
- Reset the ECM/PCM with the HDS.
- Do the ECM/PCM idle learn procedure (see ECM/PCM IDLE LEARN PROCEDURE ).
- Start the engine. Hold the engine speed at 3, 000 RPM without load (CVT in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.
- Test-drive under these conditions:
- Engine coolant temperature (ECT SENSOR 1) above 158°F (70°C)
- CVT in D, M/T in 5th
- Drive at a steady speed between 55-75 mph (90-120 km/h) for 10 seconds
- During the drive, decelerate (with the throttle fully closed) for at least 2 seconds
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P1129 indicated?
YES -Check for poor connections or loose terminals at the MAP sensor and the ECM/PCM, then go to step 1.
NO -Go to step 15.
- Monitor the OBD STATUS for DTC P1129 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 14, go to the indicated DTC'S TROUBLESHOOTING .
NO -If the HDS indicates FAILED, check for poor connections or loose terminals at the MAP sensor and the ECM/PCM, then go to step 1. If the HDS indicates NOT COMPLETED, go to step 12.