DTC P0711: Problem in ATF Temperature Sensor Circuit

• Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ).
• This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

'12 MODEL 

1. Turn the ignition switch to ON (II).
2. Check the ATF Temperature with the HDS in the A/T Data List.

   Does the ATF Temperature indicate -4 °F (-20 °C) or higher? 

   YES  - Intermittent failure, the system is OK at this time.

   NO  - Go to  3

3. Start the engine, and wait for at least 10 minutes. Test the stall speed rpm three times Stall Speed Test 
4. Check the ATF Temperature with the HDS in the A/T Data List.

   Does the ATF Temperature indicate -4 °F (-20 °C) or below? 

   YES  - Replace the ATF Temperature Sensor Replacement 

   NO  - Intermittent failure, the system is OK at this time.