Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. While holding the glove box (A), remove the glove box stop (B) on each side.
   Fig 1: Identifying Glove Box And Glove Box Stop

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Disconnect the glove box damper (A) from the glove box (B).
   Fig 2: Identifying Glove Box Damper And Glove Box

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the bolts, then remove the glove box (A).
   Fig 3: Glove Box And Bolts With Torque Specifications

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Install the glove box in the reverse order of removal.